1 NO contact potential-free 10 A/250 V AC, incandescent lamps
2000 watts, release delay with early warning switch-off and
continuous light connectible push-button. Encrypted radio,
bidirectional radio and connectible repeater function. Stand-by
loss only 0.8 watts. For built-in installation. 45 mm long, 55 mm
wide, 33 mm deep. Supply and control voltage locally 230 V. If
the supply voltage fails, the sw state remains. With
recurring supply voltage is switched off in a defined manner.
After installation, wait for the automatic short synchronization
before putting the switched load on the grid. In addition to the
radio control input via an internal antenna, this wireless
actuator can also be locally controlled with a conventional
control button that may have been ed in front of it. A glow
lamp current is not allowed. From the production week 11/14
encrypted sensors can be programmed. It is possible to switch on
bidirectional radio and/or a repeater function. Each status
change as well as received central control telegram is then
confirmed with a radio telegram. This radio telegram can be
programmed in to other actuators the GFVS software and universal
displays. Scene control: with one of the four control signals of
a button with a double rocker programmed as a scene button,
several FSR61 can be switched on or off for a scene. In the LRN
position, up to 35 wireless push-buttons are assigned to the
upper one, of which one or more central control push-buttons.
Additionally, wireless window/door contacts with the open or
closed function with the window open, wireless outdoor brightness
sensors FAH and wireless motion detector FBH. Thereafter, the
desired function of this surge sw relay is chosen: ER =
sw relay. ESV = impulse switch. If necessary, with release
delay, then + push-button continuous light = ESV with push-button
continuous light, + switch-off warning = ESV with switch-off
early warning, + push-button continuous light and switch-off
early warning = ESV with push-button continuous light and
switch-off early warning. When the button light is switched on,
buttons can be set to steady light for longer than 1 second,
which is automatically switched off after 2 hours or can be
switched off by pressing. When the switch-off warning is switched
on, the lighting flickers about 30 seconds before the time starts
and a total of 3 times at shorter intervals. If the switch-off
warning and the push-button continuous light are switched on, the
switch-off warning will be activated after the permanent light is
switched off automatically. With the lower rotary switch, the
release delay can be set from 2 to 120 minutes in the ESV
function. In ES position: infinitely normal impulse switch
function without release delay, without push-button continuous
light and without switch-off early warning. In ER position:
sw relay of the other rotary switch fulfils a safety and
power saving function in the settings except infinity: if the
switch-off command is not recognized, e.g. due to a jammed or too
hastily actuated button, the relay switches off automatically
after the time between 2 and 120 seconds has elapsed. If the FTK
has been programmed in, this time function is switched off.
Twilight switch with programmed in wireless outdoor brightness
sensor FAH and motion detection with trained radio motion
detector FBH according to the operating instructions (English
language not guaranteed.) The LED accompanies operating
instructions (English language not guaranteed.) and shows radio
control commands during operation by briefly flashing.
- Switches, power supplies and electronic power meters..
- For building installations and controlling technologies..